Shopping Cart

Your shopping cart is empty
Visit the shop

Products Page

Just to make sure everyone is on the page:

It is the buyer’s responsibility to determine the correct width(s) and length(s).  If you have questions, please contact us prior to purchasing.  ONCE CUT, THE CASE FABRIC AND PIPING ARE NOT RETURNABLE. 

Due to irregularities in the material received from the manufacturer, the actual width may of the case fabric may vary by as much as 1/4 inch (either way). We will try to minimize any variance in width differential. 

How many linear yards of tolex will you need?

                                                         USE THIS –>

Take the perimeter measurement (top + side + side + bottom), good rule of thumb:

Depths vary, but 18” width will typically work, BUT measure for accuracy. Make sure for both sides you factor in radius of the edge, exposed interior area (underhang), and approximately one inch to finish out. Don’t forget to measure the back.

Note on adhesives – Brett’s Sound Shop recommends water-based contact cement (DAP, 3M, Franklin, etc…) or 3M 77 spray adhesive, which are readily available at your local home improvement store or online; also J.E. Moser’s Hide Glue products work well. Don’t waste your money on so-called “tolex” glue.

There is lots of good information on the internet and especially on YouTube regarding covering your amp, cabinet or case.

Hot White Tolex
from $6.75

Hot White Tolex

Black Taurus
from $6.75

Black Taurus

Black Elephant
from $6.75

Black Elephant

Red Bronco Tolex
from $6.75

Red Bronco Tolex

Wine Taurus
from $6.75

Wine Taurus

LoadingUpdating...
Copyright © 2010 - 2013 Bretts Sound Shop - All Rights Reserved.
Visa PayPal